Open the enclosure and begin the initial settings.
Open The Enclosure
Use the 5mm hexagonal end of the T-shaped wrench to loosen the bolts on the top lid counterclockwise. It is not necessary to remove the bolts completely.
The bolts lack screws in the center. This design facilitates safer and more efficient operation during outdoor use, particularly at elevated heights.
Seal The Enclosure
Before closing the enclosure, ensure the orange gasket is in position, then press the lid with your hand.
Firstly, turn the two bolts near the lock hole clockwise.
Then, lock the other two bolts.
Check the enclosure and ensure no gap is left, and finally tighten all the bolts.
Refer to the tutorials below to begin your initial configuration. The steps are organized from the inside out. You aren't required to follow them in sequence; feel free to start with any step that suits you.
