> For the complete documentation index, see [llms.txt](https://outdoor.router.works/llms.txt). Markdown versions of documentation pages are available by appending `.md` to page URLs; this page is available as [Markdown](https://outdoor.router.works/manual/installation.md).

# Installation

## Open The Enclosure

Use the 5mm hexagon end on the T-shaped wrench to loosen the bolts on the top lid in a counterclockwise direction. It is not required to take off the bolts completely. 

The bolts lack screws in the center. This design facilitates safer and more efficient operation during outdoor use, particularly at elevated heights.

## Seal The Enclosure

Before closing the enclosure, ensure the orange gasket is in position, then press the lid with your hand. 

1. Firstly, turn the two bolts near to the lock hole in a clockwise direction. 
2. Then, lock the other two bolts. 
3. Check the enclosure and ensure no gap left, and finally tighten all the bolts.

***

Refer to the tutorials below to begin your initial configuration. The steps are organized from inside to outside. You aren't required to follow them in sequence; feel free to start with any step that suits you.

{% content-ref url="/pages/pUMP3SMbwVo25nwVmNQi" %}
[Insert SIM Cards](/manual/installation/insert-sim-cards.md)
{% endcontent-ref %}

{% content-ref url="/pages/Bx4Kz7j0T5DhANgenR1t" %}
[PoE Connection](/manual/installation/poe-connection.md)
{% endcontent-ref %}

{% content-ref url="/pages/2TXCNtshDYIS8XWUK3Gy" %}
[Antennas & Signals](/manual/installation/antennas-and-signals.md)
{% endcontent-ref %}

{% content-ref url="/pages/1HhT01Qipw9u7f3IERMV" %}
[Mount On A Pole](/manual/installation/mount-on-a-pole.md)
{% endcontent-ref %}