Installation
Open the enclosure and begin the initial settings.
Last updated
Open the enclosure and begin the initial settings.
Last updated
Use the 5mm hexagon end on the T-shaped wrench to loosen the bolts on the top lid in a counterclockwise direction. It is not required to take off the bolts completely.
The bolts lack screws in the center. This design facilitates safer and more efficient operation during outdoor use, particularly at elevated heights.
Before closing the enclosure, ensure the orange gasket is in position, then press the lid with your hand.
Firstly, turn the two bolts near to the lock hole in a clockwise direction.
Then, lock the other two bolts.
Check the enclosure and ensure no gap left, and finally tighten all the bolts.
Refer to the tutorials below to begin your initial configuration. The steps are organized from inside to outside. You aren't required to follow them in sequence; feel free to start with any step that suits you.